Anco-eaglin A-E Cherry Burrell Manuel d'utilisateur télécharger pdf (Page 4)

4:8

WCBFP-901

Effective 12/04

Bevel Seat Fittings

Bevel Seat connections are made up of a plain bevel ferrule mating to a threaded

bevel ferrule with a threaded hex nut. These fittings are designed and manufactured

to withstand daily disassembly, COP (clean-out-of-place), and reassembly of

process lines and equipment. A gasket can be used to ensure a

positive shutoff

under higher pressures, however is not necessary

in lower pressure applications.

Available in 1” through 4”

Fittings are made of T304 & T316L stainless steel.

Finishes are available in any standard combination.

ID polish is 180 Grit

OD polish is 150 Grit

Gaskets offered in Buna as a standard.

Meets 3A requirements

I-Line Fittings

These are the original Cherry Burrell I-Line fittings and are made up of interlocking flat face

ferrules, a flat gasket and a clamp. This interlocking, metal-to-metal design eliminates over

compression by the clamp not allowing the gasket to be extruded into the product zone.

I-Line fittings can withstand higher vibrations, temperatures and

pressures than other available connections available.

Available in 1” through 8”

Fittings are made of T304 & T316L stainless steel.

Finishes are available in any standard combination.

ID polish is 180 Grit

OD polish is 150 Grit

Electropolished I-Line Fittings are available.

Gaskets are available in Buna, EPDM, Teflon , FKM, and

Silicone as a standard.

Meets 3A requirements

WCB-Flow Products fittings and valves made of T316/T316L stainless steel are permanently

marked with original heat numbers allowing full traceability back to the original stainless steel supplier.

SPX PROCESS EQUIPMENT

WCB-FLOW PRODUCTS

1 2 3 4 5 6 7

Pas de commentaire

Anco-eaglin A-E Cherry Burrell Manuel d'utilisateur Page 4